User Manual
4
1
Getting started
CAUTIONS
Follow the cautions below when using this copier.
●
The fusing area is hot. Exercise care in this area when removing misfed
paper.
●
Do not look directly at the light source. Doing so may damage your eyes.
●
Do not switch the copier rapidly on and off. After turning the copier off, wait
10 to 15 seconds before turning it back on.
●
Copier power must be turned off before installing any supplies.
●
Place the copier on a firm, level surface.
●
Do not install the copier in a humid or dusty location.
●
When the copier is not used for a long time, for example, for consecutive
holidays, turn the power switch off and remove the power cord from the outlet.
●
When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
●
Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
●
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Cautions on laser
Wave length 770 nm - 795 nm
Pulse times 11.82 µs/7 mm
Output power 0.17 mW ± 0.01 mW
00C-1-156ex.p65 4/11/00, 9:354