Specifications

STATUS

INDICATORS

Open the bypass tray. Lift slightly on the side cover and

slide the cover out until it stops.

Push gently on both sides of the front cover and open it.

Push the toner cartridge lock release lever and pull the

toner cartridge out. Remove the toner cartridge while

supporting it with the left hand at the green label position.

●

For disposal of the old toner cartridge, contact your dealer.

After removing the toner cartridge, do not shake it or tap

on it. Doing so may cause toner to leak from the

cartridge. Put the old cartridge immediately in the bag

contained in the box of the new cartridge.

Remove the new toner cartridge from the bag. Grasp the

cartridge on both sides and shake it horizontally four or

five times. After shaking the cartridge, remove the tape.

Grasp the grip when holding the cartridge. Do not hold

the cartridge by the shutter. Be sure to only shake the

cartridge before the tape is removed.

TONER CARTRIDGE REPLACEMENT

When the toner cartridge replacement required ( ) indicator lights up,

replacement of the toner cartridge will be needed soon. Obtain a new

cartridge. When the toner cartridge replacement required ( ) indicator

blinks, the toner cartridge must be replaced before copying can be resumed.

Replace the toner cartridge by following the procedure below.

For best copying results, be sure to use only

SHARP products.

The package of SHARP toner has the Genuine

Supplies label.

Toner cartridge replacement

Grip

Toner cartridge lock

release lever

4 or 5 times

Tape

Shutter

GENUINE SUPPLIES

During a long copy run of a dark original, the

indicator may blink and the copier stop, even though

toner is left. The copier will feed toner up to 2 minutes

and then the START key (

) indicator will light up.

Press the START ( ) key to restart copying.