Instruction manual

Sharp MX-3501N
www.BERTL.com
tel. [phone]
fax. [phone]
[e-mail]
Copyright © 2006 MCA Internet, LLC dba BERTL 2-May-06
All Rights Reserved. The license under which this document is made available and applicable law prohibit any
reproduction or further transmission of any portion of this document. This document may only be viewed elec-
tronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any
reproduction of trademarks is strictly prohibited. BERTL accepts no responsibility for any inaccuracies or
omissions contained in this document.
Page 28
Color at Work
®
Copy
Image Quality
Image quality was to a good standard
across most standard output. Fine lines
were crisp and fonts could be read easily
down to 4 point.
Halftones reproduced well as were shades
of grey in monochrome mode. There was a
weakness when the device was tasked
with reproducing grey shades when in full
color mode with an assortment of shades
with cyan, magenta or yellow creeping into
the mix. This is due to inaccurate mixing of
the four colors to create composite black.
In monochrome mode, however, grey
shades reproduced well as were
representations of colors (as illustrated in
the bottom two images.)
Below: Printed image copied in text/photo mode in full color and greyscale modes
Above: Text could
be read down to 4
point.
Right: Fine lines
reproduced well in
greyscale mode.
Below: The device had a problem reproducing
grey shades in full color mode, creating output
with pronounced cyan, magenta and yellow
areas within the shade spectrum