Specifications

AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-42
50 7 Setup of send/receive
complete sound
(buzzer length)
Used to set the buzzer length from the speaker made after completion of FAX
transmission and reception. Excluding when a communication error occurs.
0 1sec
8 Not used 0
51 1 Voice answering send
level to the line
Used to set the voice answering volume to the line. Set to Large or Small with
the hardware.
0 Large
2-7 Not used 1
0
0
0
0
0
8 Line monitor range Used to set the line monitor range when the line monitor function is used.
When set to "Until NSF signal send/receive," monitoring is made until DCS or
NSF signal is received. When set to "All," all are monitored until the line is
disconnected.
0 Until NSF
signal send/
receive
52 1,2 Ringing sound volume Used to set the ringing sound volume in reception regardless of handset
installation.
The sound volume is available in the following four levels.
1 Medium Initial setup
0
3,4 Line monitor sound
volume setup
Used to set the speaker volume in line monitoring.
The volume is available in the following 4 levels.
1 Medium Initial setup
0
5,6 Speaker volume when
on-hook (Speaker
volume when DTMF
sending)
Used to set the speaker volume when the on-hook button is pressed.
The volume is available in the following 3 kinds.
1 Medium Initial setup
0
7,8 Not used 1
0
53 1,2 Transmission end sound
volume
Used to set the volume of transmission end sound from the speaker when FAX
transmission is completed. The sound volume is available in the following 4
kinds.
0 Sound NO
0
SW
No.
Bit
No.
Item Switch selection and function USA Initial value Key
operator
1: 3sec 0: 1sec
1: Small 0: Large
1: All 0: Until sending/receiving NSF signal
Bit No. 1 2
Sound NO 0 0
Small 0 1
Medium 1 0
Large 1 1
Bit No. 3 4
Sound NO 0 0
Small 0 1
Medium 1 0
Large 1 1
Bit No. 5 6
Medium 0 0
Small 0 1
Medium 1 0
Large 1 1
Bit No. 1 2
Sound NO 0 0
Small 0 1
Medium 1 0
Large 1 1
[06]SIMULATIONS ･ FAXSOFTWARESWITCH.fm 42 ページ ２００４年１０月２６日 火曜日 午後３時４４分