Specifications

[5] SIMULATIONS
1. Entering the simulation mode
A. Copy mode
The following key operations allow to enter the simulation mode from
the copy mode.
Clear key → Interruption key → “0” key → Interruption key → Main
code → Start key → Sub code → Start key
B. FAX mode
The following key operations allow to enter the simulation mode from
the FAX mode.
Clear key → Interruption key → “0” key → Interruption key → Main
code → Start key → Sub code → Start key
Or perform the following key operations:
“9” key → “ ” key → “8” key → “#” key → “7” key
2. Cancel of simulation mode
Press the clear all key to cancel the simulation mode.
Press the interruption key to interrupt the operation and return the sub
code entry menu.
3. Simulation list
A. Copy mode <Related to the FAX kit>
Main
code
Sub
code
Content
22 20 FAX print counter display
24 11 FAX print counter clear
13 Scan counter clear
26 1 Option switch display
48 1 Main scanning (Front/Rear) direction
magnification ratio adjustment (Common in copy,
FAX/OC, SPF)
6 OC mode sub scanning direction magnification
ratio adjustment in FAX mode
7 SPF mode sub scanning direction magnification
ratio adjustment in FAX mode
∗ This Service Manual describes only the items related to the FAX kit.
For the other items, refer to the Service Manual of the main machine.
B. FAX mode
Main
code
Sub
code
Content ∗
22 11 Fax related counter display
14 Fax ROM ver. Display
24 14 FAX related counter clear
46 12 FAX mode density adjustment (AUTO)
14 FAX mode density adjustment for each
resolution (Fine)
15 FAX mode density adjustment for each
resolution (Super Fine)
16 FAX mode density adjustment for each
resolution (Ultra Fine)
64 02 User switch front print
03 Soft switch setting table print
04 Dump list print
66 01 FAX related soft SW setup check/change
02 FAX related soft SW clear (Excluding
adjustment values)
03 FAX PWB memory check
04 Signal send mode
06 Confidential communication password print
07 Image memory contents output
08 Voice message clear A
10 Image memory clear
11 300bps signal send
13 Dial test
17 DTMF signal send mode
22 Handset sound volume adjustment A
30 TEL/LIU status change check
32 Received data check
34 Communication time measurement/check
37 Speaker sound volume adjustment
38 Time setup/check
∗ A: Not used
∗1: Counter display method
To display 12345: “123” (0.75sec) → Blank (0.3sec) → “456” (0.7sec) → Blank (1.0sec) → Repeat
∗2: Display after clearing each counter
“000” (0.7sec) → Blank (0.3sec) → “000” (0.7sec) → Blank (1.0sec) → Repeat
4. Details of simulations
A. Copy mode
Main
code
Sub
code
Content Operational description
Initial
value
Set
range
22 20 FAX print counter
display
Used to display the current Fax print counter value. ∗1
24 11 FAX print counter clear Used to clear the Fax printer counter. ∗2
13 Scan counter clear Used to clear the scan counter. ∗2
AR-FX2
5 – 1