Specifications

66 11 300bps signal send Used to send signals in 300bps.
13 Dial test Used to check dial pulses (10PPS), check the DTMF signal send, adjust the
dial pulse make time, and adjust the DTMF signal send level. For adjustment
procedures, refer to the previous descriptions.
17 DTMF signal send Used to send the DTMF signal. When another dial number is pressed during
DTMF signal send, the DTMF signal corresponding to the pressed dial
number is sent.
22 Handset sound volume
adjustment
<Not used>
Used to set the handset sound volume.
30 TEL/LIU status change
check
Used to display the following status change of TEL/LIU.
• Polarity reverse relay
• External telephone hook switch relay
32 Reception data check Used to check the fixed data received from the line. Since a nit to send the
fixed data is required, this mode is not required in this market.
34 Communication time
measurement display
Used to make transmission and reception tests, measure the time required
for transmission (reception) of image data in the communication, and inform
of it.
• Measurement range
Transmission: From sending of the flag signal before sending of the image
data to sending of RCP frame.
Reception: From reception of the flag signal before reception of the image
data to reception of RCP frame.
The communication test is performed in the standard display. After
completion of communication, the time measured in this mode is checked.
• The setup items in transmission are as follows:
• Communication means: memory transmission
• Image quality: Standard
• Density: Light
ECM: ON
Transmitter record: OFF
37 Speaker sound volume
adjustment
Used to set the speaker sound volume.
38 Time setup/check Used to display and correct the time (year, month, day, day of week, hour,
minute) installed in the FAX PWB.
Display/Key operation
<Signal send level>
0db: Signals are sent in 0db.
Soft SW: Signals are sent in the
level set with the soft switch.
<Signal pattern>
1: No signal
2: 111111
3: 111110
4: 000000
5: 010101
6: 000001
<Signals>
Dial pulse (10PPS)
DTMF signal
Display/Key operation
<Signal send level>
0db: Signals are sent in 0db.
Soft SW: Signals are sent in the
level set with the soft switch.
<Send dial number>
10-key
Key operation
1: Small
2: Large
Display
Signal LOW HIGH
HS1
HS2
EXHS
ON
ON
ON
OFF
OFF
OFF
Key operation
0: No sound
1: Small
2: Medium
3: Large
AR-FX2
5 – 5