Specifications

SW
NO.
Data
NO.
Item Switch selection and contents of functions Initial value
User
program
No.
Remark
SW7 1 MH fixing Used to fix the image data compression method in
transmission to MH. However, when SW52-7 (V.34 mode
function) is OFF or when SW52-7 (V.34 mode function)
is ON in transmission, MH fixing is effective. This is
because MMR function is indispensable in V.34 mode
and the other party machine may perform checking.
When SW52-7 (V.34 mode function) is ON in reception,
this function is disabled.
NO 0 Setup in a
communication
other than V.34
2 Reserved 0
3 Busy tone
detection
Used to set whether the busy tone signal is detected or
not in calling or pseudo calling of external telephone.
YES 1
4 Reserved 0
5 Reserved 0
6 Max. length of
reception
Used to set the max. length of reception. 1.5 m 0 Max. length 1m
in transmission
is monitored
with MCU.
7 Modem speed
fixing in
reception
Used to set the start speed of reception procedure when
receiving from an other party other than V.34. Reception
procedure is made in the set speed.
No fixing 0 Setup in a
communication
other than V.34
8 0
SW8 1 Memory
transmission/Dire
ct transmission
default setup
Used to set whether the transmission mode is memory
transmission or direct transmission after pressing C/A key
or in auto clear operation.
Memory
transmissio
n
0 152
2 Memory
reception
When set to 0, reception is not made in auto reception
under the following state: Cover open, unit error (toner,
drum, developing section error), paper exit tray full,
recording paper jam, document jam, no print paper.
When set to 1, memory reception is enabled.
YES 1
3 Reserved 0
4 Reserved 0
5 Remote
reception
direction
Used to set whether remote select function is used or not. YES 1
6 Reserved 0
7 Reserved 0
8 Reserved 0
1: YES
2: NO (Depends on the other party
machine.)
1: YES 2: NO
1. No limit 0: 1.5m
SW7 Bit No. 7 8
No fixing 0 0
V.29 9600 bps 0 1
V.27ter 4800 bps 1 0
V.17 14400 bps 1 1
1. direct transmission 0: Memory transmission
1. YES 0: NO
1. YES 0: NO
AR-FX2
6 4