Specifications

SW
NO.
Data
NO.
Item Switch selection and contents of functions Initial value
User
program
No.
Remark
SW18 1 Reserved 0
2 Reserved 0
3 Reception size
specification
(Shows
reception
capacity.)
Used to set the receivable document width which is
informed the other party when receiving a
communication. The setup items are as follows:
By the
installed
cassette
0 ∗1: Refer to
the following
descriptions.
4 0
511″ reception
capacity setup
Used to set the recording width of DIS signal when the
set paper size is Ledger (11 × 17, main scanning
279.4mm, sub scanning 4318mm), Letter R (8.5 × 11R,
main scanning 215.9mm, sub scanning 279.4mm), Letter
(8.5 × 11, main scanning 279.4mm, sub scanning
215.9mm) or Legal (8.5 × 14, main scanning 215.4mm,
sub scanning 355.6mm).
For each setup, be careful of the following items.
<255mm and 215mm>
When the other party sends documents of 11″ width or
A3 width, the size is automatically reduced to 255mm in
the other party’s machine.
<303mm, 255mm, and 215mm>
When the other party sends documents of 303mm width,
and when reception is made on Ledger, Letter, or Letter
R (rotation print) paper, the data over the paper size are
cut out. (When printed on Legal paper in rotation
printing, the data are not cut.) In this case, if the other
party’s machine is of inch spec and sends documents of
11″ width, there is no problem. If the other party’s
machine is of AB spec and sends document of A3 width,
data are cut.
303/255/
215 mm
0 ∗2 Refer to the
following
descriptions.
6 Output method
in A3 width
reception
Used to set the output method when A3 width data are
sent from the other party’s machine.
11″ width
print
0 126
7 Reserved 0
8 Reserved 0
SW19 1 Protocol monitor Used to set whether the protocol monitor of one
communication is printed or not.
NO 0
2 Send
reservation
interruption
enable in recall
mode
Used to set whether send reservation interruption is
allowed or not in standby for recall.
Enable 1 115
SW18 Bit No. 3 4
By the installed cassette 0 0
215 mm 1 0
255 mm (215 & 255 mm) 0 1
303 mm (215 & 255 & 303 mm) 1 1
∗1: When “By the installed cassette” is selected, the max. recording size on the tray which is set to ON in the recording paper tray selection
(SW27-2 – 5) becomes effective.
When all of the recording paper tray selection (SW27-2 – 5) are set to OFF, the reception of A3 (A4, B4, A3) is allowed. (The soft SW is
not changed.)
∗2: When 11″ paper which allows reception of FAX is set, setting of this SW informs of the reception capability.
If the setting of SW18-3 to -4 (Reception size designation) is set to “By the installed cassette”, this setting has the priority.
1: 255/215 mm 0: 303/255/215 mm
1: Data of A3 width is
printed.
0: Data of 11″ width is
printed.
1: YES 0: NO
1: Enable 0: Disable
AR-FX2
6 – 8