Specifications

SW
NO.
Data
NO.
Item Switch selection and contents of functions Initial value
User
program
No.
Remark
SW19 3 Output only in
case of
protocol
monitor error
Effective only when SW19-1 is set to 1 (YES). Used to
set whether protocol monitor is outputted only when a
communication is not completed normally due to a
communication error or it is outputted after completion of
every communication.
NO 0
4 Reserved 0
5 Reserved 0
6 Reserved 0
7 Time
designation 1
of
communication
record table
Used to set whether the communication record table is
printed at the designated time 1 or not.
Disable 0 139
8 Time
designation 2
of
communication
record table
Used to set whether the communication record table is
printed at the designated time 2 or not.
Disable 0 139
SW20 1 Line sound
monitor range
Used to set the line sound monitor range when the line
monitor function is used.
When set to “Until NSF signal send/receive”, monitoring
is made until the NSF signal is sent or received. When
set to “All”, monitoring is made for all until the line is
disconnected.
OFF 0 When set to
“11”, set to “00”.
2 0
3 Line monitor
display
Used to set whether the communication speed and the
reception level are displayed on the LCD or not.
NO 0
4 Operation
panel key
sound
Used to set whether the key click sound of FAX related
keys are made or not when operating in the FAX mode.
Ring 0
5 Receivable
memory
capacity left
Used to set the remaining memory capacity for
acceptance of call. (This is not the memory judgement
level during reception.)
128 Kbyte 0
6 Memory over
during reception
Used to set whether the received data are outputted or
destroyed when memory is over during reception.
Output 1
7 Reserved 0
8 Reserved 0
1: Only in case of an
error
0: After completion of
every communication (All
output)
1: Enable 0: Disable
1: Enable 0: Disable
SW20 Bit No. 1 2
OFF 0 0
Until NSF signal send/receive 0 1
All 1 0
1: YES 0: NO
1: Not ring 0: Ring
1: 64Kbyte 0: 128Kbyte
1: Output 0: Not output
AR-FX2
6 – 9