Owner's Manual

KEY OPERATOR PROGRAMS

Erase Adjust

Set the initial setting of the amount of the erase area with this program.

When "ERASE ADJUST" is selected and the OK key is pressed, the following display will appear.

1. Adjust the value for the edge erase mode and center erase mode

using the and keys.

●

The value can be set from 1/4" to 1" in 1/4" increments.

2. Press the OK key.

Stream Feeding

This program is used to enable the stream feeding mode of a RSPF. When the stream feeding mode is

enabled, additional originals which are set in the document feeder tray within 5 seconds after the

previous original was fed will be fed and copied automatically.

To enable the stream feeding mode, highlight "STREAM FEEDING" and

press the OK key to display a check mark in the check box.

To disable this function, select this program and press the OK key again to

clear the check mark in the check box.

Rotation Copy

If this program is set, the image of originals will rotate when the orientation of the originals does not

match that of the copy paper.

Rotation copy will function only when the auto paper select or auto image mode has been selected.

NOTE:

If the image is rotated in reduction copying, the position of the image in relation to copy paper will

vary with the orientations of the originals and copy paper.

To enable rotation copy, highlight "ROTATION COPY" and press the OK

key to display a check mark in the check box.

To disable this mode, select this program and press the OK key again to

clear the check mark in the check box.

ERASE ADJUST

4 inch

(1/4~1)

Original Copy paper Copy

Ar-M208_keyope_sec.book 10 ページ２００２年６月１２日　水曜日　午後３時４１分