Service manual

AR-M351U/M451U, AR-M355U/M455U SIMULATION 9 - 29
Since this simulation cannot change the Fax destination, use SIM
66-2 to change the FAX destination.
Operation/Procedure
1) Select START/END of the network scanner trial mode with 10-
key.
2) Press [START] key.
Max. 500 menus can be scanned.
Operation/Procedure
1) Select YES/NO of the toner save mode with 10-key.
2) Press [START] key.
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
(Default: 1 for Europe, 0 for the others)
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
(Default: 0)
Operation/Procedure
1) Select the number corresponding to the operation mode with
10-key.
2) Press [START] key.
(Default: 0)
26-10
Purpose Setting
Function
(Purpose)
Used to set the network scanner trial mode.
Item Operation
0 END Trial mode cancel Default
1 START Trial mode start
26-18
Purpose Setting
Function
(Purpose)
Used to set YES/NO of toner save operation. (This
function is valid only in Japan and UK versions.
(Depends on the destination setting of SIM26-6.)
For the other destinations, the same setting can
be made by the user program P22.)
Item Specifications Operation mode
0 YES Toner save mode is set.
1 NO Toner save mode is not set. Default
26-30
Purpose Setting
Function
(Purpose)
Used to set the operation mode conforming to the
CE mark (Europe safety standards). (Conforming
to soft start when driving the fusing heater lamp.)
Item Specifications Operation mode (Common)
0 NO CE mark control NO (Normal operation)
1 YES CE mark control YES (Heater lamp soft start
operation)
SIMULATION 26-6
DESTINATION SETUP. SELECT 1-10, AND PRESS START.
1.USA 2.CANADA 3.INCH
4.JAPAN 5.AB_B
6.EUROPE 7.UK 8.AUSTRALIA
9.AB_A 10.CHINA
1
SIMULATION 26-10
NETWORK SCANNER TRIAL SETTING. SELECT 0-1, AND PRESS
START.
0.END
1.START
1
SIMULATION 26-18
TONER SAVE MODE SETTING. SELECT 0-1, AND PRESS START.
0. YES
1. NO
1
26-35
Purpose Setting
Function
(Purpose)
Used to set whether the same continuous troubles
are displayed as one trouble or the series of
troubles with SIM 22-4 when the same troubles
occur continuously.
Section
Item Specifications
0 ONCE When two or more troubles of a same kind occur
continuously, the troubles are displayed as one
trouble in the trouble history of SIM22-4.
1 ANY When two or more troubles of a same kind occur
continuously, the troubles are displayed straightly
as two or more troubles in the trouble history of
SIM22-4.
26-38
Purpose Setting
Function
(Purpose)
Used to set CONTINUE/STOP of printing when
maintenance timing is over and the count value
reaches 110% of replacement timing (life).
Section Other
Item Specifications
0 PRINT CONTINUE Print continue
1 PRINT STOP Print stop
SIMULATION 26-30
CE MARK CONTROL SETTING. SELECT 0-1, AND PRESS START.
0. NO
1. YES
1
SIMULATION 26-35
TROUBLE MEMORY MODE SETTING. SELECT 0-1, AND PRESS
START.
0. ONCE
1. ANY
1
SIMULATION 26-38
LIFE OVER SETTING. SELECT 0-1, AND PRESS START.
0. PRINT CONTINUE
1. PRINT STOP
1