Service manual

AR-M351U/M451U, AR-M355U/M455U SIMULATION 9 - 68
Operation/Procedure
1) Select YES/NO of hard disk read/write check.
2) Press [START] key.
During testing, "EXECUTING" is displayed. When test is com-
pleted normally, "OK" is displayed. If not, "NG" is displayed.
Operation/Procedure
1) Select the number corresponding to the self diag check mode.
2) Press [START] key.
During the self diag operation, "EXECUTING" is displayed.
If the self diag is completed normally, "0" is displayed. If not, any
value but 0 is displayed.
* = SHORT SELF-TEST, EXTENDED SELF-TEST
Operation/Procedure
1) Enter 1 with 10-key.
2) Press [START] key.
The result of the hard disk operation check (the self diag operation
of the SMART function) is printed out.
62-3
Purpose Operation test/Check
Function
(Purpose)
Used to check the operation of the hard disk (read/
write). (Only in the model with a disk installed)
(All areas check)
Section MFP controller (HDD)
Item Operation
1 YES Execution
2 NO Cancel
Completion Press [CUSTOM SETTINGS] key.
62-6
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the hard disk.
(The self diag operation of the SMART function is
executed.) (Only in the model with a disk installed)
Section MFP controller (HDD)
Item Clear
1 SHORT SELF-TEST Partial test
2 EXTENDED SELF-TEST All areas test
SIMULATION 62-3
HDD R/W TEST(ALL).
ARE YOU SURE?
1. YES
2. NO
1
Press [START] key.
SIMULATION 62-3
HDD R/W TEST(ALL). EXECUTING···.
SIMULATION 62-3
HDD R/W TEST(ALL). OK. (or NG)
Completion Press [CUSTOM SETTINGS] key.
62-7
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the hard disk.
(The result of the self diag operation of the
SMART function is printed out.) (Only in the model
with a disk installed)
Section MFP controller (HDD)
Item Clear
0 TRAY SELECT Tray select auto only (Selection inhibited)
1 PRINT START Print start
Select 1 and
press [START] key.
Press [CUSTOM SETTINGS] key
or [START] key.
SIMULATION 62-6
SMART OFFLINE TEST.
1. SHORT SELF-TEST
2. EXTENDED SELF-TEST
1
SIMULATION 62-6
*. EXECUTING···.
Press [START] key.
SIMULATION 62-6
*. COMPLETE.. (result: 0)
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. SELECT SETTING, AND PRESS
START.
0. TRAY SELECT :AUTO ONLY
1. PRINT START
1
0
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. EXECUTING···
0. TRAY SELECT :1