Service manual

AR-M351U/M451U, AR-M355U/M455U SIMULATION 9 - 86
Operation/Procedure
(Display message)
Operation/Procedure
1) Enter the number corresponding to the select IN signal YES/
NO setting with 10-key.
2) Press [START] key.
When the printer parallel I/F is used and a trouble is generated in
the communication between the PC and the printer, change the
setting of this simulation.
Operation/Procedure
During check, "CHECKING" is displayed. When check is com-
pleted normally, "OK" is displayed. In case of an error, "NG" is dis-
played.
(Display message)
67
67-2
Purpose Operation test/Check
Function
(Purpose)
Used to check the operation of the parallel I/F of
the printer. (This simulation is for production only,
and requires a special tool for execution. Not used
in the market.)
Section MFP controller
Item Operation Interface/Communication
WAITING Waiting
READY Check start OK
OK Check end (Normal)
STAGE*NG Check end (Error in stage *. *: 1 - 11)
lWith READY displayed,
press [START] key.
Press [CUSTOM SETTINGS] key.
67-11
Purpose Setting
Function
(Purpose)
Used to set YES/NO of the parallel I/F select
signal of the printer.
Section MFP controller
Item Operation Interface/Communication
Item Default
0OFF 1
1ON
SIMULATION 67-2
CENTRO PORT CHECK.
CENTRO PORT: READY
SIMULATION 67-2
CENTRO PORT CHECK.
CENTRO PORT: OK (or STAGE7 NG)
SIMULATION 67-11
CENTRO SELECT IN SIGNAL SETTING. SELECT 0-1, AND PRESS
START.
0. OFF
1. ON
67-16
Purpose Operation test/Check
Function
(Purpose)
Used to check the operation of the network card.
Section MFP controller
Item Operation Interface/Communication
CHECKING Checking
OK Check end (Normal)
NG Check end (Error)
Check end Press [CUSTOM SETTINGS] key.
SIMULATION 67-16
NETWORK INTERFACE CARD CHECK.
NIC: CHECKING
SIMULATION 67-16
NETWORK INTERFACE CARD CHECK.
NIC: OK (or NG)