Setup guide

15
USING THE MACHINE WITH A PARALLEL OR USB CONNECTION
ENGLISH
11
When the interface selection screen
appears, select [USB] and click the
[Next] button.
12
When you are asked if you wish to
install the display fonts, select an
answer and click the [Next] button.
13
Follow the on-screen instructions.
Read the message in the window that
appears and click the [Next] button.
When the installation completed screen
appears, click the [OK] button.
14
Click the [Close] button in the window
of step 7.
When a message appears prompting you
to connect the machine to your computer,
click the [OK] button.
15
Make sure that the power of the
machine is turned on, and then
connect the USB cable (page 19).
Windows will detect the machine and the
Plug and Play screen will appear.
16
Follow the instructions in the Plug and
Play screen that appears in your
version of Windows to begin the
installation.
After completing the above steps, repeat the
installation procedure from step 2 if you are
installing the PCL5e, PS, PPD, or PC-Fax
driver.
1.
Repeat the installation procedure from step 2.
If you are installing the PC-Fax driver, insert
the "Software CD-ROM" that shows "Disc 2"
on the front of the CD-ROM and click the
[PC-Fax Driver] button in step 7.
2. When the select printer driver to install
screen appears, remove the checkmark from
[PCL6] and select the checkbox of the printer
driver that you wish to install.
This completes the installation.
• After installation, see "CONFIGURING THE
PRINTER DRIVER" (page 24) to configure
the printer driver settings.
• If you installed the PS printer driver or the
PPD driver, the PS display fonts can be
installed from the "PRINTER UTILITIES"
CD-ROM that accompanies the PS3
expansion kit. See "INSTALLING THE PS
DISPLAY FONTS" (page 22).
• If you are using the machine as a shared
printer, see "USING THE MACHINE AS A
SHARED PRINTER" (page 20) to install the
printer driver on each of the client computers.
In Windows 2000, if the following
screen appears while the files are being
copied (the message may appear more
than once), click the [Yes] button.
After the installation, a message
prompting you to restart your
computer may appear. If this message
appears, click the [Yes] button to
restart your computer.
Caution
Note
!!install_arp27_Eng.book 15 ページ ２００７年１月１１日 木曜日 午前９時７分