Setup guide

24
CONFIGURING THE PRINTER
DRIVER
After installing the printer driver, you must configure the printer driver settings appropriately for the
options that have been installed and the size and type of paper loaded in the machine. Follow the
steps below to configure the printer driver.
1
Click the [start] button and then click
[Printers and Faxes].
In Windows 98/Me/NT 4.0/2000, click the
[Start] button, select [Settings], and then
click [Printers].
2
Click the "SHARP AR-XXXX" printer
driver icon and select [Properties] from
the [File] menu.
If you are using Windows NT 4.0/2000/XP/
Server 2003, go to step 4.
3
In Windows 98/Me, click the [Setup]
tab.
4
Click the [Configuration] tab and set
the printer configuration based on the
options that have been installed.
Set the printer configuration properly.
Otherwise, printing may not take place correctly.
5
Click the [Set Tray Status] button and set the
size and type of paper loaded in each tray.
Select a tray from the "Paper source" menu,
set the size of paper loaded in the tray from
the "Set Paper Size" menu, and select the
type of paper from the "Set Paper Type"
menu. Repeat for each of the trays.
6
Click the [OK] button in the "Set Tray
Status" window.
7
Click the [OK] button in the printer
properties window.
If the PPD driver is installed, see "When the PPD driver is installed" (page 25).
Note
If [Printers and Faxes] does not appear in
the [start] menu in Windows XP, click the
[start] button, click [Control Panel], click
[Printers and Other Hardware], and then
click [Printers and Faxes].
If the machine is used as a network printer,
you can click the [Auto Configuration] button
to automatically configure the settings
based on the detected machine status.
Note
Note
You can check the options that are
installed and the tray settings by
printing out the "PRINTER SETTINGS
LIST" in the custom settings of the
machine. Follow these steps to print
out the "PRINTER SETTINGS LIST":
Press the [CUSTOM SETTINGS] key,
touch the [LIST PRINT] key, touch the
[PRINTER TEST PAGE] key, and
then touch the [PRINTER SETTINGS
LIST] key.
Note
!!install_arp27_Eng.book 24 ページ ２００７年１月１１日 木曜日 午前９時７分