Operation Manual, Quick Start Guide

Table Of Contents

BEFORE USING THE MACHINE

LOAD PAPER INTO THE TRAY 1 - 4

Loading envelope in tray 1

Load the paper with the copy and print side facing up. The diagram shows an example of printing on the front side.

The maximum number of sheets 50 may not exceed the indicator line.

Pull out the paper tray.

Gently pull the tray out until it stops.

To load paper, go to step 3. To load a different size of

paper, go to the next step.

Adjust guide plates A and B to match

the longitudinal and transversal

dimensions of the paper to be loaded.

• The guide plates A and B are slidable. Squeeze the

separator plate lever and slide to the desired paper size.

Adjust to the non-standard paper size so that the paper

will not be too loose or too tight.

• To load SRA3 paper, the position of the guide must be

adjusted. For details, see the User's Manual.

Insert the paper into the tray.

Load the paper with the print side facing up. The stack must

not be higher than the indicator line.

Fan the paper well before loading it. Otherwise, multiple

sheets may feed at once and cause a misfeed.

Gently push the paper tray into the

machine.

Push the tray firmly all the way into the machine slowly.

Forcefully inserting the paper may cause skewed feeding

and paper misfeeds.

When loading envelopes in the tray 1, set the paper type.

► CHANGE THE SETTING OF THE PAPER TRAY (page 25)