Operation Manual, Software Setup Guide

Changing the port

Click the [Start] button, select [Settings] →

[Device]

→ [Devices and Printers].

In Windows 8.1/Windows Server 2012, right-click the [Start]

button, select [Control Panel] → [View devices and printers]

(or [Devices and Printers]).

Open the printer properties window.

(1) Right-click the printer driver icon of the machine.

(2) Select [Printer properties].

Adding or changing a port.

(1) Click the [Ports] tab.

(2) Click the [Add Port] button.

Select the port type and click the [New Port]

button.

• Standard TCP/IP Port

This is the standard printer port provided by the operating system.

(1) Click the [Next] button.

(2) Enter the machine's IP address in [Printer Name or IP

Address] and click the [Next] button.

(3) Click the [Finish] button.

• SC2 TCP/IP Port

Use this port if you will use Tandem Print on an IPv4 network.

(1) Enter the machine's IP address.

(2) Make sure that [LPR] is selected.

(3) Make sure that [lp] is entered.

(4) Click the [OK] button.

• SC-Print2005 Port

If the printer driver is installed using a "Custom

installation" with "Use an IPP or IPPS port" selected, the

"SC-Print2005 Port" is added.

Follow the on-screen instructions.

Click the [Close] button in the screen of step 4.

Click the [Apply] button in the screen of step 3.

• To change to an existing port, select the port from the list

and click the [Apply] button.

• The "SC2 TCP/IP Port" is added when the printer driver is

installed using a "Custom installation" with "Specify the MFP

IP address" or "Search for MFP" selected.

• The "SC2 TCP/IP Port" cannot be used if the machine is

connected to an IPv6 network.

• When using a port created using "Standard TCP/IP Port", in

the screen that appears after you click the [Configure Port]

button in the screen of step 3, make sure the [SNMP Status

Enabled] checkbox is not selected ( ). If the [SNMP Status

Enabled] checkbox is selected ( ), it may not be possible

to print correctly.