Owner's Manual

57
USING THE
EDITING
FUNCTIONS
4
5
Place the originals on the original feed tray
or on the glass.
. After aligning the edges of the originals, set
them
face up on the original feed tray and
align the slides to the edges of the originals.
. Place the original on the glass face down with
the bottom toward you and the left side
centered against the original scale.
Press the SET key.
. The set margin default is 7 mm.
. To change the margin:
Press the
0mm or 30mm key to select
the desired margin setting, and press the SET
key.
. When combining image shifting with duplex
copying, select FRONT for the front side and
BACK for the back side of the copy.
6
Select the desired copy size, exposure,
reproduction ratio and copy quantity.
7
Tip: Margins can be created also in the bypass
copy mode. To do this, set the paper in the
sheet bypass (see page 50), and press the
desired COPY-SIZE key
to select the paper
size. If LETTER-R paper is used, press the
corresponding COPY-SIZE key twice.
Press the START key.