Service manual

AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 33
64 01 Self print (1by2 mode) [Function]
The status of the optical section is ignored and printing of one page is made. Also when the
print command is received from the host, printing is made.
When this simulation is executed, warm-up is performed and the ready lamp is lighted. (Since,
however, the scanner is disabled, initializing is not made.)
Enter the code number and press [OK]/[ENTER]/[START] key to start paper feed from the
selected cassette and print in the selected pattern.
* For 4 – 99, flip.
[Operation]
The operation is similar to simulation 26-02.
66 01 FAX soft SW setting
(Executable only when the
FAX is installed.)
[Function]
Use to check the FAX soft SW setting.
Every time when the key is pressed, the bit on the first line is switched 0 and 1.
[Operation]
02 FAX soft SW initializing
(excluding the adjustment
values) (Executable only
when the FAX is installed.)
[Function]
Use to initializing FAX soft SW.
[Operation]
Main
code
Sub
code
Contents Details of function/operation
Code number Pattern Display item
01by21 BY 2
1 Grid pattern CHECK
2 White paper WHITE
3 Black background BLACK
1) Initial display
∗ [Clear] key: FAX control is terminated.
2) Enter a 3-digit value of soft SW No. (To
enter the fourth digit, shift to the left.),
and the press [OK]/[ENTER] key.
"xxxxxxxx" is the set content.
∗ Select 2: Returns to the soft SW No. entry
display.
3) Select 1
4) Change with 1-8 of [Numeric] key and
the press [OK]/[ENTER] key.
"xxxxxxxx" is the set content.
∗ Select 2: Returns to the soft SW No. entry
display.
5) Select 1
After 2sec, returns to "1) Initial display".
ENTER FAX SOFT SW. #
(3 DIGITS) SW.___
No.### xxxxxxxx
CHANGE? 1:YES 2:NO
No.### xxxxxxxx
USE # KEY 12345678
No.### xxxxxxxx
STORED? 1:YES 2:NO
STORED
1) Initial display
After 2sec, FAX control is terminated.
INITIALIZED