Service manual

AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 40
5. Trouble codes
A. Trouble codes list
66 38 Time setting/check
(Executable only when the
FAX is installed.)
[Function]
Use to check the time setting.
[Operation]
67 50 USB receive speed
adjustment (USB1.1)
(AR-203E only)
Used to set the limitation on the print data receive speed of USB2.0 (Full speed) port (USB port
on the machine).
→ When print images from USB2.0 (Full speed) port are disturbed, change the setting and try
again.
When this simulation is executed, the currently set code number is displayed.
Enter the code number corresponding to the adjustment value, and press [START] key to
change the setting.
Main
code
Sub
code
Contents Details of function/operation
1) Initial display
∗ [Clear] key: FAX control is terminated.
2) Select 1
"xxxx.xx.xx(xxx)" is the current value. (No
revision of display)
3) Select 1
∗ Select 2: Returns to "1) Initial display".
4) Enter the year in 4 digits.
5) Enter the month in 2 digits.
6) Enter the day in 2 digits.
"xxxx.xx.xx(xxx) is the entered value.
∗ Select 2: Returns to "1) Initial display".
7) Select 1
After 2sec, returns to "1) Initial display".
2) Select 2
"xx:xx" is the current value.
3) Select 1
∗ Select 2: Returns to "1) Initial display".
4) Enter o'clock in 2 digits.
5) Enter minute in 2 digits.
"xx:xx" is the current value.
∗ Select 2: Returns to "1) Initial display".
6) Select 1
After 2sec, returns to "1) Initial display".
SELECT TO SET
1:DATE 2:TIME
xxxx.xx.xx(xxx)
CHANGE? 1:YES 2:NO
INPUT YEAR
(4 DIGITS)____.__.__
INPUT MONTH
(1-12) 1998.__.__
INPUT DAY
(1-31) 1998.01.__
xxxx.xx.xx(xxx)
STORED? 1:YES 2:NO
STORED
xx:xx
CHANGE? 1:YES 2:NO
INPUT HOUR
(0-24) __:__
INPUT MINUTE
(00-59) 01:__
xx:xx
STORED? 1:YES 2:NO
STORED
Code number Setting Speed
1FAST ↑ Fast
2NORMAL1
3NORMAL2
4SLOW ↓ Slow
Main
code
Sub
code
Details of trouble
E1 00 IMC communication trouble
10 IMC trouble
13 IMC flash ROM error
81 IMC communication interface error (Parity)
82 IMC communication interface error (Overrun)
84 IMC communication interface error (Framing)
E7 01 Duplex model memory setup error, memory not-
detected error
02 LSU trouble
10 Shading trouble (Black correction)
11 Shading trouble (White correction)
Main
code
Sub
code
Details of trouble
E7 16 Abnormal laser output
F2 02 Toner supply abnormality
04 Improper cartridge (Destination error, life cycle error)
F5 02 Copy lamp lighting abnormality
F6 10 FAX board trouble
H2 00 Thermistor open
H3 00 Heat roller high temperature detection
H4 00 Heat roller low temperature detection
L1 00 Feeding is not completed within the specified time
after starting feeding. (The scan head locking switch
is locked)