Service manual

AR-203E/5420/M200/M201 USER PROGRAM 12 - 4
B. Print mode
*
1
: The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing speed does not increase considerably.
*
2
: When the 250-sheet paper feed unit is installed.
19 AE LEVEL ADJUST 1: SPF/RSPF
(Adjustment to 5 levels
is possible.)
2: DOCUMENT GLASS
(Adjustment to 5 levels
is possible.)
• This is used to adjust the exposure level.
• The automatic exposure level can be adjusted separately for the document
glass and the RSPF.
• For the procedure for adjusting the exposure and guidelines for numeric
values. The factory default setting for the exposure level is center.
20 LANGUAGE 1: AMERICAN ENGLISH
2: ENGLISH
3: FRENCH
4: SPANISH
:
:
• This is used to set the language used in the display.
21 RESET FACTORY 1: Yes
2: No
• This is used to return all settings to the factory default settings.
22 SORT AUTO
SELECT
1: ON
2: OFF
• Use this setting to enable or disable sort auto select mode.
24 CHECK RSPF
OPEN
1: ON
2: OFF
• You can set the operation that takes place if the [START] key ( ) is
pressed when the RSPF is not completely closed. (Valid only when the
multi-bypass paper feed is used.)
25 VALID COPY
WIDTH
1: 8.5x11
2: 5.5x8.5
• Set the allowed paper sizes for copying from the bypass tray. When
"5.5x8.5" is selected, a copy of a letter size original will only be printed up
to invoice size.
28 LSU SETTING 1: ON
2: OFF
• Select whether copying is only allowed when the polygon motor is rotating,
or also when the polygon motor is stopped.
29 PAPER TYPE 1: PLAIN PAPER
2: HEAVY PAPER
• Set the temperature of the fusing unit when the bypass tray is used.
Normally "HEAVY PAPER" should be selected.
30 DISPLAY
CONTRAST
1: LIGHTER
2: LIGHT
3: NORMAL
4: DARK
5: DARKER
• Set the contrast of the display.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
1 FORCED OUTPUT 1: ON
2: OFF
• When this function is enabled, printing in printer mode will automatically
continue using a different size of paper if the specified size of paper runs out
in all trays. This feature does not function in copy mode.
2 USB 2.0 MODE
SWITCH *
1
1: FULL-SPEED
2: HI-SPEED
• This sets the USB 2.0 data transfer speed. To obtain the fastest speed when
using the USB 2.0 connector, first verify that your computer meets the
system requirements (operating system and driver), and then use this
program to change the USB 2.0 mode to "Hi-Speed". Note that the setting
should not be changed while running a TWAIN driver.
3AUTO TRAY
SWITCH*
2
1: ON
2: OFF
• If the paper runs out during printing and there is paper of the same size in
another tray, this function automatically switches to that tray (excluding the
bypass tray). The function can be disabled.