Service manual

AR-203E/5420/M200/M201 UNPACKING AND INSTALLATION 5 - 10

3) Remove the rear cover for the document glass.

<1> Remove the two screws and then remove the right glass

holder.

<2> Slide the rear cover for the document glass to remove it.

<3> Remove the table glass.

4) Attach the Scanner condensation prevention mylar at the 3

positions on the rear side of the main unit as described below.

Note: The hole should be covered with the mylar.

Align the edge of the mylar to the R part (the yellow line in the

diagram below) so that the hole of the metal plate is covered

as much as possible.

Align the edge of the mylar to the R part (the yellow line in the

diagram below) so that the hole of the metal plate is covered

as much as possible.

Attach along the edge of the projection (the yellow line in the

diagram below).

5) Attach the Optical right hole mylar B at the 2 positions shown

in the diagrams below which are at the top of the rear side of

the main unit.

Note: The holes should be covered with the mylar.

Attach along the edge of the cushion (the yellow line in the dia-

gram below).

Align with the inside line of the bent part (the yellow line in the

diagram below).

Align with the raised part (the yellow line in the diagram

below).

Match the center of the mylar (in the horizontal direction) to the

center of the raised part.

Stick the excessive part on the side.