Service manual

AR-203E/5420/M200/M201 UNPACKING AND INSTALLATION 5 - 12

10) Attach the Scanner motor metal plate cushion covering the

bottom part of the Scanner motor lower mylar.

Note: The hole under the motor unit should be covered.

Attach the cushion to cover the gap between the mylar and the

metal plate (the yellow mark).

Press the cushion with a sharp-pointed stick or something to

fill the gap between the mylar and the metal plate.

11) Attach the motor connector and the snap band to the original

position.

12) Attach the Scanner UPG mylar J3 to cover the hole on the

right side of inside of the scanner.

Note: The mylar should cover the hole shown by the arrow in

the diagram.

Attach along with the bent part of the metal plate and align the

edge of the mylar with the line shown in the diagram (the yel-

low line in the diagram).

13) Attach the Fan housing cushion to the cooling fan at the posi-

tion shown in the diagram below.

Cover the top and the right side of the fan housing when you

see the fan housing from the backside of the machine.

Note: Please make sure the double-sided tape is not exposed

where the cushion is sticking out from the edge of the

fan housing.

Attach the cushion leaving 3 - 7mm from the edge so that the

gap between the Fan housing cushion and the filter of the rear

cabinet is filled for sure.

14) Attach the parts removed in the items 1), 2), and 3).

Stick the lower part of the cushion to the mylar, too.

View from

the arrow A

Back side

Attach the cushion leaving3-7mm

from the edge.

Reference position

3 - 7mm