Service manual

AR-203E/5420/M200/M201 ADJUSTMENTS 9 - 5
E. Copy density adjustment procedure
Use SIM 46-1 to set the copy density for each copy mode.
For selection of modes, use the [Exposure mode selector] key (or
[ ] [ ] key for the AR-M200/M201).
(1) Test chart (UKOG-0162FCZZ) setting
1) Place the test chart so that its edge is aligned with the A4 (Let-
ter) reference line on the document table. Then place a A4
(14" x 8 1/2") white paper on the test chart and close the docu-
ment cover.
(2) Perform the adjustment in each mode.
1) Execute SIM 46-01 (300dpi). To adjust in 600dpi, execute SIM
46-02.
2) AR-203E/5420
Select the mode to be adjusted with the exposure mode select
key. Set the exposure level to 3 for all adjustment. (Except for
the auto mode.)
2) AR-M200/M201
Select the mode to be adjusted with the exposure key. Set the
exposure level to 3 (center) for all adjustment. (Except for the
auto mode.)
3) Make a copy.
Check the adjustment level (shown in the above table) of the
exposure test chart (Sharp Gray Scale).
(When too bright): Decrease the value displayed on the copy
quantity display.
(When too dark): Increase the value displayed on the copy quan-
tity display.
∗ The value can be set in the range of 1 - 99.
3. High voltage adjustment
A. Main charger (Grid bias)
Note:
• Use a digital multi meter with internal resistance of 10MΩ or
more measurement.
• After adjusting the grid LOW output, adjust the HIGH output. Do
not reverse the sequence.
Procedures
1) Set the digital multi meter range to DC700V.
2) Set the positive side of the test rod to the connector CN11-3
(GRID) of high voltage section of the power PWB and set the
negative side to the frame ground (power frame).
3) Execute SIM 8-2. (The main charger output is supplied for 30
sec in the grid voltage HIGH output mode.)
4) Adjust the control volume (VRG1) so that the output voltage is
580 ± 12V.
Adjustment
mode
Exposure mode
display lamp
Sharp gray chart
adjustment level
Auto mode Auto lamp ON "3" is slightly copied.
Manual mode Manual lamp ON "3" is slightly copied.
Photo mode Photo lamp ON "3" is slightly copied.
Manual T/S
mode
Manual lamp/Photo lamp ON "3" is slightly copied.
Auto T/S
mode
Auto lamp/Photo lamp ON "3" is slightly copied.
Test chart
White paper
(1) (2)
Exposure mode select key/display lamp
[Exposure mode selector] key/
display lamp
(1)
(2)
1 12
22
211
(2) Exposure key
(1) Exposure mode, level display
TEXT
| | | | |
Adjustment
mode
Display
item
LED
Sharp gray chart
adjustment level
Auto mode AE COPY mode lamp "3" is slightly copied.
Text mode TEXT PRINT mode lamp "3" is slightly copied.
Photo mode PHOTO SCAN mode lamp "3" is slightly copied.
Text T/S mode TSTXT PRINT mode lamp
SCAN mode lamp
"3" is slightly copied.
Auto T/S mode TSAE COPY mode lamp
SCAN mode lamp
"3" is slightly copied.
Sharp Gray Scale adjustment level
Non toner
save
mode
Toner
save
mode
1 10 W 23456789
Slightly copied.
Not copied.
1 10 W 23456789
Slightly copied.
Not copied.
VRG1