Service manual

AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 3
4. Descriptions of various simulations
Main
code
Sub
code
Contents Details of function/operation
01 01 Mirror scan operation [Function]
When [OK]/[ENTER]/[START] key is pressed, the home position is checked and the mirror base
performs full scan at the speed of the set magnification ratio.
During operation, the set magnification ratio is displayed.
The mirror home position sensor status is displayed with the "Drum replacement required lamp
(or the copy mode indicator for the AR-M200/M201)". (When the mirror is in the home position,
the lamp lights up.)
During operation, the copy lamp lights up.
When [Clear] key is pressed, if the operation is on the way, it is terminated and the machine
goes to the sub code entry standby mode.
[Operation] (AR-M200/M201)
02 Mirror home position sensor
(MHPS) status display
[Function]
Monitors the mirror home position sensor, and makes the "Drum replacement required lamp (or
the copy mode indicator for the AR-M200/M201)" turn on during the sensor ON status.
[Operation] (AR-M200/M201)
06 Aging of mirror scanning [Function]
When [OK]/[ENTER]/[START] key is pressed, the mirror base performs full scan at the speed of
the set magnification ratio.
During operation, the set magnification ratio is displayed.
After 3sec, the mirror base performs full scan again.
∗ When [OK]/[ENTER]/[START] key is pressed once, the ready lamp remains OFF.
The mirror home position sensor status is displayed on the "Drum replacement required lamp
(or the copy mode indicator for the AR-M200/M201)." (The lamp is ON when the mirror is in the
home position.)
During aging, the copy lamp is ON.
[Operation] (AR-M200/M201)
The operation is similar to simulation 01-01.
02 01 SPF/RSPF aging operation
(Only the AR-203E/M200/
M201 with the SPF/RSPF
installed)
[Function]
When [OK]/[ENTER]/[START] key is pressed, the set magnification ratio is obtained. For the
SPF, the single-face document transport is performed. For the RSPF, the duplex document
transport is performed.
However, the operating conditions don't matter and the operation is not stopped even in case of
a jam. Also the magnification ratio is displayed on the LCD/display.
[Operation] (AR-M200/M201)
The operation is similar to simulation 01-01.
1) Initial display 2) [ZOOM]/[COPY RATIO]
key
2) [ ] key
2) [ ] key
3) [OK]/[ENTER]/[START]
key
01-01 SCAN CHK
- 100% +
01-01 SCAN CHK
- 78% +
01-01 SCAN CHK
- 99% +
01-01 SCAN CHK
- 101% +
01-01 SCAN CHK
EXECUTING... - 78% +
1) Initial display
01-02 MHP-SENSOR
EXECUTING...