Manual

Before Starting Playback
+ 3 types of remote control codes operate this system:
RC-1, RC-2 and RC-3. Ifyou operate this system by
remote control along with SHARP Blu-ray Disc Player or
DVD Player placed next to it simultaneously, switching
the remote control code (both the main unit and remote
control) to one of the signals (RC-1, RC-2 or RC-3) will let
you operate only with this system,
+ Make sure to set the main unit and remote control to the
same remote code. You can not operate the system if they
are not set to the same code.
3
Point the remote control at the main unit, then
press and hold the ON SCREEN for more than
10 seconds.
Remote control sensor
Buttons under the cover
.....................®®®................
:1
,,!+,d_i;_
Example: Setting the code to "RC-3".
4 Press POWER (on the remote control) to turn on
the system.
NOTE
+ If the battery of the remote control becomes depleted or
needs to be replaced, the remote control code is reset to
RC-1 on the remote control.
Performing a RESET resets the remote control code to
RC-1 on the main unit.
Set the remote control code on the main unit and remote
control, as necessary.
+ The following buttons on the remote control can be
operated regardless of the remote control code.
- FM, BD/AUX, iPod/_, SUB WOOFER, CENTER LEVEL,
DYNAMIC VOL, MULTI, DISPLAY, MUTE, VOL+, VOL-,
SOUND MODE, AUDIO DELAY, DIMMER
1 Press and hold 3 first and then POWER on
the remote control together for more than 5
seconds.
2 Press POWER (on the main unit) to turn off the
system.
POWER
I
|
"0
o
w
£.
O
O
(_- 35