Operation Manual, User's Manual

1-34
BEFORE USING THE MACHINE►BEFORE USING THE MACHINE
MOTION SENSOR
(MX-M3071/MX-M3571/MX-M4071/MX-M5071/MX-M6071 only)
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode (Motion Sensor Mode Only).
Three settings are available for the detection range ( / / ).
You can warn with notification message when the motion sensor responds while the machine's power is set to OFF in
the power ON/OFF schedule settings. By setting an e-mail address for the alert destination, you can have detection
information which informs the response of the motion sensor.
The motion sensor detects the movement of sources of heat.
The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
The motion sensor may not operate correctly in the conditions below.
An object is in front of the motion sensor
There are scratches or dirt on the motion sensor cover
The motion sensor is directly exposed to sunlight or air flow
The motion sensor is damaged
There is a source of heat such as a heater nearby
An object is moving in the detection range
To enable the motion sensor
"Settings (administrator)" select [System Settings] → [Energy Save] → [Eco Setting] → [Sleep Mode Power Level].
To issue a voice alert when the motion sensor detects movement
Select the [Send a Voice Alert when the motion sensor detects movement] checkbox in "Settings (administrator)" -
[System Settings] → [Energy Save] → [Power ON/OFF Schedule Setting].
Motion sensor
Near Far
Detection range
Approx.
maximum
1.5 m
60 degrees