Operation Manual, User's Manual

7-80
SETTING MODE►SYSTEM SETTINGS
Common Settings
Paper Settings
Paper Tray Settings
Paper Weight
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, coloured
paper, and user type paper.
You can select "60 - 89 g/m
2
" or "90 - 105 g/m
2
" ("16 - 23 lbs." or "23+ - 28 lbs.").
Operation Settings
Condition Settings
Data List
To specify [One Sided] or [Two Sided] printing in Data List.
Tandem Connection Setting
When two machines are used as network printers using TCP/IP protocol, use this setting to configure the port number
and IP address of the machine used as the tandem client machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting. (Normally this setting is not necessary.)
Disabling of Client Machine Mode
To prohibit tandem reception, enable this setting. (Normally this setting is not necessary.)
Custom Link Setting
The stored Web addresses can be displayed in the display area of the setting menu.
Click a custom link to jump to the website of the stored address.
Device Control
Various devices mounted on the machine can be set.
Condition Settings
Actions When Maximum Number of Sheets that can be Stapled is Reached
Sets whether to display a message to select a remedy when the maximum number of staples has been reached.
Saddle Fold/Stitch Position Adjust
Adjust the folding or staple position when saddle stitching.
This can only be set on the machine's operation panel.
Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that
is outside the range with the paper in the tray.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER
(page 1-12)".
• To use the tandem function when user authentication is enabled, the same login name and password must be used on
both the master machine and client machine. If the same login name and password are not used, the page count may not
be added to the appropriate user count or only the master machine may print.
• The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, do not change
the port number.