SETUP MANUAL

ENGLISH
7
E
Turning Power On/Off
Caution
• Turnonthemonitorfirstbeforeturningonthecomputeror
playbackdevice.
• WhenswitchingthemainpowerswitchorthePOWER
buttonoffandbackon,alwayswaitforatleast5seconds.
Ashortintervalmayresultinamalfunction.
Turning on the main power
Main power switch
Whenyouturnonthemainpower,themonitorentersstandby
state.
Offmode,whenmainpowerisoff.
Caution
• Themainpowermustbeturnedon/offwiththemainpower
switch.Donotconnect/disconnectthepowercordorturn
thebreakeron/offwhilethemainpowerswitchison.
• Foracompleteelectricaldisconnection,pulloutthemain
plug.
Turning power on/off
PressthePOWERbuttontoturnthepowerON/OFF.
YoucanalsoturnthepowerON/OFFbypressingthe
MONITORONbutton/MONITOROFFbuttonontheremote
controlunit.
Power LED
POWER button
Status Status of the monitor
Bluelit Poweron
Redlit Poweroff(Standbystate*)
* StandbymodewhenPowerSaveModeissettoOn.
NetworkedstandbymodewhenPowerSaveModeissetto
Off.
Networkedstandbymodeallowsthemonitortobeturned
onvianetwork(LAN,RS-232C,andHDMICEC).
TIPS
• Whenthemonitoristurnedonforthefirsttimeafterbeing
shippedfromthefactory,thesettingsscreenappears.
• Whenthemainpowerswitchisoff,themonitorcannotbe
turnedon.
n
Operation mode
Whenthemonitoristurnedonforthefirsttimeafterbeing
shippedfromthefactory,theoperationmodesettingscreen
willbedisplayed.SetittoMode1orMode2.
Mode1istherecommendedsettingandconformsto
the“NormalConfiguration”asdefinedintheEcoDesign
Regulation(2019/2021).
Mode1......OffIfNoSignalsettingcannotbechanged.Ifthere
isnosignalforapprox.5minutes,thismonitor
automaticallyentersstandbymode.
OffIfNoOperationandPowerSaveModeareset
toOn.(Thesesettingscannotbechanged.)
Ifthereisnooperationfor4hoursormore,this
monitorautomaticallyentersstandbymode.Power
consumptioninstandbystateisalsominimized.
Mode2......OffIfNoSignal,OffIfNoOperation,andPower
SaveModearesettoOff.Thesesettingscanbe
changed.
Evenafterbeingset,changescanbemadeusingOperation
Mode,locatedinthemenuofthemonitor.(SeeOPERATION
MANUAL.)