User's Manual

www.ninjakitchen.com
13
English
IMPORTANT: Place the motor base on a clean,
dry, level surface such as a counter or table top.
1 Make sure that the motor base is plugged in for
use. No lights will turn on.
2 Add ingredients to the cup.
NOTE: Do not overfill! to avoid spilling, do not add
ingredients past the “MAX” fill line.
3 Place the blade assembly onto the cup and twist it
on tightly until you have a good seal. (Fig. 1)
4 Turn the cup upside down and place it onto the
motor base, aligning the tabs on the cup with the
motor base. Turn it clockwise, until you feel it click
into place. The Timer light will illuminate.(Fig. 2)
5 Press one of the buttons to activate. (Fig. 3)
Fig. 1 Fig. 2
Use
Fig. 3 Fig. 4 Fig. 5
ASSEMBLY USE REMOVAL
NOTE: When using the AUTO-iQ
™
presets, the unit will
operate using pulses, pauses and continuous runs.
The pauses allow the contents of the cup to settle.
When the timer reaches “0”, it will stop by itself.
6 To remove the cup, ensure that the motor has
stopped running. Then turn the cup counter
clockwise (Fig. 4) and pull straight up to remove.
(Fig. 5)
7 Turn the cup upright and remove the blade
assembly by twisting the blade assembly counter
clockwise. Be sure to store the blade assembly
attached to an empty cup when not in use.
8 Twist the Sip & Seal
™
lid onto the cup to enjoy your
drink on the go. Press flip top cap firmly into the
opening to get the best seal. The flip top cap locks
open when pressed backward.
9 Make sure that the motor base is unplugged when
not in use.
10 To remove the motor base unit, tip the unit forward
from the rear to easily disengage the suction cups.