Operation Manual, User's Manual

4-14
FACSIMILE►BASIC TRANSMISSION METHODS
FAXING A TWO-SIDED ORIGINAL
Follow the steps below to automatically transmit both sides of a two-sided original.
1
Press the [DUPLEX] key ( ) on the operation panel, select “2-Sided” with the
[ ] or [ ] key, and press the [OK] key.
2
Select "Portrait-Booklet", "Portrait-Tablet",
"Landscape-Booklet", and "Landscape-Tablet" with the
[] or [] key.
• Booklets and tablets Two-sided originals that are bound at the side are booklets, and
two-sided originals that are bound at the top are tablets.
• Duplex scanning is cancelled when the transmission is completed, or when the [CA]
key is pressed.
• Duplex scanning of two-sided originals is only possible when a Document feeder is
used. Automatic scanning of both sides of an original is not possible when the
document glass is used.
• The image of the back side of the original is rotated 180 degrees if needed at the time
of transmission, and thus there is no need to change the orientation at the receiving machine.
• To cancel duplex scanning, select "1-Sided" in step 1 and then press the [OK] key.
• Do not use a non-standard document size. This may cause a scanning error or image cutoff. For the paper sizes that
can be used with the machine, refer to
Paper sizes that can be used for fax mode (page 4-3).
3
Press [OK] key.
BOOKLET TABLET