Operation Manual, User's Manual

4-15
FACSIMILE►BASIC TRANSMISSION METHODS
Transmission settings (memory transmission mode and direct transmission mode)
Transmission modes include memory transmission, where the original is temporarily scanned into memory before
transmission, and direct transmission, where the original is transmitted directly without being scanned into memory.
There are two types of memory transmission: Storing transmission jobs (memory transmission)
(page 4-17), where all
pages of the original are scanned into memory before transmission begins, and Quick On-line
(page 4-17), where the
destination is dialled after the first page is scanned and the remaining pages are transmitted as they are scanned.
During a memory transmission, it may happen that the memory becomes full while the originals are being scanned.
See If the memory becomes full during transmission of a stored transmission job
(page 4-17), and see If the memory
becomes full during a quick online transmission (page 4-17)
If there are too many pages and memory transmission is not possible, you can press the [COMM. SETTING] key ( )
to switch from memory transmission to direct transmission. When direct transmission is used, transmission begins after
the current job is completed, allowing you to give priority to a transmission job. As such, direct transmission is a
convenient means of performing an interrupt transmission when there are a large number of stored transmission jobs.
To switch between memory transmission and direct transmission, see the following "Faxing by direct transmission".
Faxing by direct transmission
When transmission is performed manually using an extension phone connected to the machine or using on-hook dialling,
direct transmission is automatically selected. (Memory transmission is not possible.)
1
Press the [COMM.SETTING] key.
The communication settings screen appears.
2
Select "TX" with the [ ] or [ ] key.
The communication settings screen can also be displayed from the function selection screen.
Press the [SPECIAL FUNCTION] key ( ) to display the special function selection screen, select "Comm. Setting" with
the [ ] or [ ] key, and press the [OK] key.
3
Select "Direct TX" with the [ ] or [ ] key and press the
[OK] key.
4
Dial the fax number and press the [B/W START] key.
When using the document glass, multiple original pages cannot be transmitted in a single transmission.
For the basic procedure for sending faxes, refer to "BASIC PROCEDURE FOR SENDING FAXES
(page 4-8)".
• To change from "Direct Transmission" back to "Memory Transmission", select "Memory TX" in step 3.
• To cancel a direct transmission, press the [C] key.