Operation Manual, User's Manual

4-16
FACSIMILE►BASIC TRANSMISSION METHODS
Faxing by manual transmission (using the [SPEAKER] key ( ))
1
Press the [SPEAKER] key ( ).
When this key is pressed, a message regarding volume adjustment will appear briefly followed by the dial
entry screen. You can adjust the speaker volume (high, middle, or low) by pressing the
[ ] or [ ] key.
Note that this will not change the volume setting in the system settings. Ringing will be heard from the
speaker on the rear side of the machine when the [SPEAKER] key ( ) is used for dialling.
2
Dial the fax number and press the [B/W START] key.
For the basic procedure for sending faxes, refer to "BASIC PROCEDURE FOR SENDING FAXES (page 4-8)".
• When the Address Review (page 6-23) function is turned on, the [SPEAKER] key ( ) cannot be used for
transmission.
• To cancel dialling using the [SPEAKER] key ( ) when you need to redial the number or because transmission was
interrupted, press the [SPEAKER] key ( ) once again.
• As the original is not stored in memory when direct transmission and manual transmission are used, the following
functions cannot be used. Broadcast transmission SENDING THE SAME DOCUMENT TO
MULTIPLE
DESTINATIONS IN A SINGLE OPERATION (page 4-31), AUTOMATIC TRANSMISSION AT A SPECIFIED TIME
(page 4-30), Recall Setting (Busy) (page 6-24), duplex scanning, Address Review, and others.
• When a fax is sent by direct transmission or manual transmission, the fax is sent after the connection with the
receiving machine is established.
3
Select "TX" and press the [OK] key.