Service manual

132 Removal and replacement ENWW

Pickup sensor flag

1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).

2 Use a flatblade screwdriver to pry up the sensor flag.

3 Before you remove the pickup sensor flag, examine the position of the torsion spring and the

motion of the sensor flag. At reinstallation, the spring must be reinstalled correctly to ensure

that the flag’s motion is correct.

Figure 57. Removing the pickup sensor flag

4 Rotate the pickup sensor flag and slide the flag to the left, clearing the hole in the printer

frame.

CAUTION Be very careful not to break the

part that holds the pickup sensor

flag in place.