Service manual

144 Removal and replacement ENWW

Laser/scanner plate

1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).

2 Unplug the fan connector (callout 1; see callout 1 on page 140 for another view of the fan

connector) from the engine controller PCA and then unwind the fan cable from the cable

holders that are on top of the laser/scanner plate.

3 Unplug the flat, flexible cable (callout 2) from the laser/scanner.

4 Unplug two connectors (callout 3) from the engine controller PCA.

5 Remove one grounding screw (callout 4).

6 Remove four screws (callout 5), and then lift the laser/scanner plate out of the printer.

Figure 69. Removing the e-label reader (1 of 3)