Service manual

152 Removal and replacement ENWW

Flat, flexible cable

1 Remove the following covers and assemblies:

• I/O cover (see page 113)

• DIMM cover (page 115)

• rear cover (page 116)

• front cover (page 119)

• control panel (page 120)

• top cover assembly (page 121)

• formatter (page 147)

2 Use a flatblade screwdriver to release two tabs (callout 1) on the cable guide.

3 Slide the guide toward the back of the printer and then lift the guide and the flat, flexible cable

off of the drive assembly plate.

Note The flat, flexible cable is pre-folded to match the locations of its connectors. To take advantage of

the folds, make sure that the cable is situated correctly before reinstalling the cable guide.

Figure 77. Removing the flat, flexible cable