Service manual

ENWW Chapter 6 Removal and replacement 155
5 Remove two screws (callouts 5 and 6; callout 6 indicates a grounding screw).
6 Rotate the bottom of the assembly away from the printer to clear two tabs (callout 7) at the
top of the assembly and then rotate the top of the assembly away from the printer.
Figure 80. Removing the engine controller PCA (3 of 5)
Reinstall note
Make sure that you insert the two tabs (callout 7 in figure 80) into the slots in the printer frame
before replacing the screws.
2
2
5
6
2
7