Service manual

ENWW Chapter 6 Removal and replacement 171
6 To remove the small rollers, rotate the roller holders toward the back of the printer until the
hinges are clear of obstruction, and then lift the holders off of the printer.
Note Each roller holder should have a spring attached. Make sure that the springs are in place before
reinstalling a roller holder.
7 Use a flatblade screwdriver to pry the small rollers out of the holders.
Figure 96. Removing the top-output-bin delivery assembly (3 of 3)
Reinstall note
Two types of small roller holders are installed on the printer, and they are not interchangeable.
Make sure you replace the roller holders in their correct positions on the printer.