Service manual

176 Removal and replacement ENWW

Trays

250-sheet feeder and 500-sheet feeder pickup roller

Note Procedures for removing the pickup roller from a 250-sheet feeder are identical to the procedures

for removing the pickup roller from a 500-sheet feeder. In the photographs for these procedures,

a 500-sheet feeder is shown.

1 Lift the printer off of the feeder and then remove all of the paper from the feeder.

2 Press down the lift plate and pull the tray out of the feeder.

3 Turn the feeder so that it rests on its back side.

4 Insert the flatblade screwdriver into the slot on the right roller-shaft cover (callout 1) and then

pry the cover off of the feeder.

5 Insert the flatblade screwdriver into the slot (callout 2) on the left roller-shaft cover and then

pry the cover off of the feeder.

Figure 101. Removing the pickup roller from a 250-sheet or 500-sheet feeder (1 of 2)