Service manual

66 Operation ENWW
CARTRIDGE LOW *CONTINUE
STOP
Determines how the printer behaves if the print cartridge is
low. The ORDER CARTRIDGE message first appears when
about 10 percent of the toner remains in the print cartridge
at 5 percent coverage (about 600 pages remaining). Print
quality is not guaranteed if you print after receiving this
message.
● CONTINUE: The printer continues to print, and the
message appears until you replace the print cartridge.
● STOP: The printer pauses printing until you replace the
print cartridge or press (SELECT) before each job
to print it. The message appears until you replace the
print cartridge.
CARTRIDGE OUT *CONTINUE
STOP
Determines how the printer reacts if the print cartridge is
empty.
● CONTINUE: The printer continues to print, and the
REPLACE CARTRIDGE message appears until you
replace the print cartridge. HP does not guarantee
print quality if you select CONTINUE after a REPLACE
CARTRIDGE condition. Replace the print cartridge as
soon as possible to ensure print quality.
● STOP: The printer stops printing until you replace the
print cartridge.
If the end of drum life is reached, the printer stops,
regardless of the CARTRIDGE OUT setting.
JAM RECOVERY *AUTO
OFF
ON
Determines how the printer behaves if a jam occurs.
● AUTO: The printer automatically selects the best mode
for printer jam recovery (usually ON).
● OFF: The printer does not reprint pages following a
jam. Printing performance might be increased with this
setting.
● ON: The printer automatically reprints pages after a
jam is cleared.
RAM DISK *AUTO
OFF
Determines how the RAM disk is configured. (This item
does not apply to printers with only 32 MB of RAM, such
as the HP LaserJet 2300L and
HP LaserJet 2300 printers.)
● AUTO: The printer determines the optimal RAM-disk
size based on the amount of available memory.
● OFF: The RAM is disabled.
NOTE: If you change the setting from OFF to AUTO or from
AUTO to OFF, the printer automatically reinitializes when it
becomes idle.
LANGUAGE *ENGLISH
Several others
Selects the language for the messages that appear on the
control-panel display.
Table 14. Configure device menu—system-setup submenu
Item Values Explanation