Service manual

– 11 –

CD-CH1500H/CD-CH1500W

System Connections (CD-CH1500W Only)

Setting the AC voltage selector

Check the setting of the AC voltage selector located on the rear panel before plug-

ging the unit into an AC socket. If necessary, adjust the selector to correspond to the

AC power voltage used in your area.

Turn the selector with a screwdriver until the appropriate voltage number

appears in the window (110 V, 127 V, 220 V or 230 V - 240 V AC).

Connecting the AC power lead

After making all connections, plug the unit. If you plug the unit first, the unit

will enter the demonstration mode.

Notes:

Plug the AC power lead into an AC socket, after any connections.

Unplug the AC power lead from the AC socket if the unit will not be in use for a pro-

longed period of time.

Setting the FM/AM span selector

The International Telecommunication Union (ITU) has established that member coun-

tries should maintain either a 100 kHz or a 50 kHz interval between broadcasting fre-

quencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows

the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).

Before using the unit, set the SPAN SELECTOR switch (on the rear panel) to the

interval (span) of your area.

To change the tuning zone:

Press the ON/STAND-BY button to enter the stand-by mode.

Set the SPAN SELECTOR switch (on the rear panel) as follows.

For 50 kHz FM interval (9 kHz in AM) 50/9

For 100 kHz FM interval (10 kHz in AM) 100/10

Whilst pressing down the VOLUME button, press the ON/STAND-

BY button until "ALL CLEAR" appears.

Caution:

This operation will erase all data stored in memory including clock and timer settings,

and tuner and CD presets.