User Manual

ENGLISH

When TIMER indicator is flashing

The unit is overheated when TIMER indicator is flashing.

Due to a problem in the speaker circuit, the unit will enter the stand-by mode

automatically.

In this case, take the following corrective actions.

1. Unplug the AC power plug from the AC socket.

2. Make sure that the unit vent is not blocked.

3. Make sure that the speaker wires have been correctly connected to the

speaker terminals.

4. After checking items 2 and 3 above, wait for 2 or 3 hours before trying to use

the unit.

5. Reconnect the AC power lead.

Note:

If the TIMER indicator flashes again during use, please unplug the AC power plug,

and contact a SHARP authorised service centre.

References

– Troubleshooting Chart –

Troubleshooting Chart (continued)

■ Before transporting the unit

1. Press the POWER button to turn the power on.

2. Press the CD button.

3. Press the

7 OPEN/CLOSE button to open the disc tray.

Remove all CDs from the unit.

4. Press the

7 OPEN/CLOSE button to close the disc tray.

Make sure that “NO DISC” is displayed.

5. Press the POWER button to enter the stand-by mode, and then unplug the

AC power lead from the AC socket.

■ Clearing all the memory (reset)

1. Press the POWER button to enter the power stand-by mode.

2. Whilst pressing down the

0 /

R button and X-BASS/DEMO button, press

the POWER button until “CLEAR AL” appears.

Caution:

This operation will erase all data stored in memory including clock, timer settings,

tuner preset, CD programme, and other set-up details.

E-39