Operating instructions

Operating Instructions Chapter 5

C4000 Standard/Advanced

Subject to change without notice

Installation and mounting

5.2.2 Mounting with side bracket

The side bracket is made of die cast zinc ZP 0400. It is enamelled in black. The side

bracket will be covered by the device after mounting. But it is only suitable for mounting

surfaces lying parallel to the desired protective field because the alignment of sender and

receiver can only be adjusted by a maximum of ±2.5° after mounting.

 Attach the bolts of the side bracket with a torque of between 5 and 6 Nm. Higher

torques can damage the bracket; lower torques provide inadequate protection against

vibration.

 When mounting the bracket, note the distance and the position of the sliding nuts as

described in chapter 11.5 “Dimensional drawings” on page 84f.

Fig.

Composition

of the

side bracket

Notes

Part No. 2019506