Operating instructions

E-50
Basic Operation
These functions allow you to reduce the power consumption. See page
38
for the procedure details.
Selecting the Economy Mode
Power Save Function
Function to control the quantity of projected light. Select “ (Low Power Mode)” or “ (Standard Mode)” to
decrease or increase brightness, fan noise and power consumption.
Quantity of light is 85 %.
Power consumption is about 350 W.
Quantity of light is 100 %.
Power consumption is 380 W.
•“Power Save” mode is factory preset to “ (Standard Mode)”.
• Even when selecting “ (Low Power Mode)” in “Power Save” mode, fan noise may increase if internal temperature rises
enough to activate the cooling function.
Monitor Out/RS-232C Off Function
This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not using these ports, “MNTR Out/RS232C” can be set to “ ” to
reduce standby power consumption.
Standby power for Monitor Out/RS-232C
connection turned off.
Monitor Out/RS-232C on
CAUTION
• Set “MNTR Out/RS232C” to “ ” when using the Sharp Advanced Presentation Software (supplied).
•“MNTR Out/RS232C” is factory preset to “ ”, and “Auto Power Off” is factory preset to “ ”.
Automatic Power Shutoff Function
When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen
message, “Power OFF in 5 min.” will appear five minutes before the power is automatically turned off.
Power automatically shuts off after about 15
minutes of no signal input.
Automatic Power Shutoff disabled.