Operating instructions

E-59
Multiple Function
Using Extended Functionality Features
Stack Projection
For brighter images, two projectors can be stacked using the Stack Setting function.
Basic
Computer
RGB cable
RGB cable
RS-232C cable
RS-232C OUT
RS-232C IN
Projector 2
INPUT1
OUTPUT
INPUT1
Stack Setting
Master
Stack Setting
Slave
Projector 1
Below are the steps for making a stack projection as shown in the diagram above.
1 Set the “Stack Setting” of Projector 1 to “Master”.
(See page
52
for details.)
2 Set the “Stack Setting” of Projector 2 to “Slave”.
(See page
52
for details.)
3 Select the same RS-232C transmission speed for both Projector 1 and Projector 2.
(See page
53
for details.)
4 Adjust the “Set Inputs” setting as the table below.
(See page
53
for details.)
Set Inputs
ON
OFF
OFF
OFF
OFF
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Set Inputs
ON
OFF
OFF
OFF
OFF
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5
Projector 1 (Master)
Projector 2 (Slave)
Set input terminals you will use to “ON”.
Set input terminals you will not use to “OFF”.