Specifications

33
DK-A10H
DK-A10H(BK)
References
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
 General
 Remote control
 Tuner
 CD player
 iPod
 Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet or on
the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc until normal playback is possible
(about 1 hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.
 If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
Symptom Possible cause
 The clock is not set to
the correct time.

Is the Summer Time switch set to the
correct setting? (Refer to page 13)
 Did a power failure occur? Reset
the clock. (Refer to page 34)
 When a button is
pressed, the unit does
not respond.
 Set the unit to the power stand-by
mode and then turn it back on.
 If the unit still malfunctions, reset it.
(Refer to page 34)
 No sound is heard.  Is the volume level set to “0”?
 Are the headphones connected?
 iPod door not fully
open/close.
 Set the unit to the power stand-by
and turn it on again.
 Reset it. (Refer page 34)
Symptom Possible cause
 The remote control does
not operate.
 Is the AC power lead of the unit
plugged in?
 Is the battery polarity correct?
 Are the battery dead?
 Is the distance or angle incorrect?
 Does the remote control sensor
receive strong light?
Symptom Possible cause
 The radio makes unusual
noises continuously.
 Is the unit placed near the TV or
computer?
 Is the FM aerial or AM loop aerial
placed properly? Move the aerial
away from the AC power lead if it
is located nearby.
Symptom Possible cause
 Playback does not start.
 Playback stops in the
middle or does not
perform properly.
 Is the disc loaded upside down?
 Does the disc satisfy the standards?
 Is the disc distorted or scratched?
 Playback sounds are
skipped, or stopped in
the middle of a track.
 Is the unit located near excessive
vibrations?
 Is the disc very dirty?
 Has condensation formed inside the
unit?
Symptom Possible cause
 No sound is produced.
No image appears on
the TV/monitor.
 The iPod is not playing.
 The iPod is not properly connected
to the unit.
 Is the AC power lead of the unit
plugged in?
 The video cable is not properly
connected.
 The TV/monitor’s input selection is
not properly set.
 iPod will not charge  Wrong iPod adaptor is used.
 The iPod is not making full contact
with the iPod connector.
 The main unit is in stand-by mode.