Operation Manual, User's Manual
Table Of Contents
4-47
FACSIMILE►BASIC TRANSMISSION METHODS
SPECIFYING THE ORIGINAL SCAN SIZE USING
NUMERIC VALUES
Specify the original size by numeric values after placing the original in the following cases:
• When scanning a non-standard size original such as a postcard
• When the size is not detected correctly
The width can be from 131 mm to 432 mm (5-11/64" to 17"), and the height can be from 140 mm to 297 mm (5-33/64" to
11-5/8").
When the scan size is specified by numeric values, the send size cannot be specified.
1
Tap the [Detail] key to change to normal mode.
► CHANGING MODES (page 1-11)
2
Tap the [Original] key.
3
Tap the [Scan Size] key.
4
Tap the [Direct Entry] key, and enter
the scan size.
• Tap the areas displaying width and height sizes
respectively, and enter the sizes using the numeric keys.
• It is convenient to use to finely adjust the entered
size.
5
Tap the [OK] key.
After the settings are completed, tap twice.
On the base screen, check that the specified size is displayed on the [Original] key.
To cancel the specified size settings:
Tap the [Auto] key.
Original
2-Sided
Tablet
2-Sided
Booklet
A4 A4AutoAuto
Scan Size Send Size
Image Orientation
100%
Others
Address Fax Number
N-Up
Put Multiple Pages in A Page
Slow Scan Mode
Scan Thin Paper Original
reception memory
100%
Speaker
Start
CA
Address Book
Preview
Dual Page Scan
Divide into 2 Pages
Scan Size
(25 ~ 432)
mm
mm
(25 ~ 297)
AB Inch
OK
Direct Entry
297
X
Y
Custom Size
Address Fax Number
N-Up
Put Multiple Pages in A Page
Slow Scan Mode
Scan Thin Paper Original
reception memory
Speaker
Start
CA
Address Book
Preview
100%
Others
420
Auto A4
Dual Page Scan
Divide into 2 Pages