user manual
Table Of Contents
- Introduction
- Easy Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Signal Adjustment (“SIG-ADJ” Menu)
- Adjusting the Projected Image (“SCR-ADJ” Menu)
- Adjusting the Projector Function (“PRJ-ADJ1/2” Menu)
- Auto Sync (Auto Sync Adjustment)
- Auto Power Off Function
- Auto Restart Function
- Speaker Setting
- Selecting the Transmission Speed (RS-232C)
- Fan Mode Setting
- System Lock Function
- Keylock Function
- Selecting the Quick Start Menu
- COMPUTER2 Select
- Setting the FUNCTION Button Operation
- STANDBY Mode
- DLP® LinkTM
- DLP® LinkTM Invert
- Returning to the Default Settings
- Checking the Lamp Life Status
- Setting Up the Projector Network Environment (“Network” Menu)
- Appendix
17
Easy Start
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page
49.)
2
Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3 After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the
Setup Guide.
4. Adjust the projected image with the Setup Guide
_P. 27
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
_P. 29
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode,
and use O/Q to select the audio input terminal.
On the
projector
On the remote
control
INPUT list
1 COMPUTER1
INPUT Audio
2 MONITOR OUT
S-VIDEO
S
VIDEO
V
On the
projector
On the remote
control
6. Select the Input mode
_P. 30
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
_P. 26