User Manual

UNPACKING AND INSTALLATION INSTRUCTIONS

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC-

TIONS FOUND ON WALL AND TOP CABINET TEMPLATE.

THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET

TEMPLATE.

NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD. See WALL CONSTRUCTION on

page 6.

MOUNTING SCALE PLATE

Attached 2 Scale Plates !, with tape (not included). See Figure 6 and WALL TEMPLATE for locations.

Figure 6

7 OVEN INSTALLATION

MOUNTING PLATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.

2. Match 5/8” holes (not in stud/s), drilled through WALL AND TOP CABINET TEMPLATE into wall to correspond-

ing holes on Mounting Plate.

3. Insert Toggle Bolts into matched openings on Mounting Plate. Put Toggle Nuts on Toggle Bolts. See Figure 7.

4. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts

through the holes in the wall with the Toggle Nuts closed. Figure 8. Use Wood Screws 1 to attach the Mounting

Plate to studs.

NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting

Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the

Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be

withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before

insertion.

5. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you

and turn clockwise to tighten. Figure 9.

Mounting

Plate

Figure 7 Figure 8 Figure 9

Space more than

wall thickness

Wall

Mounting Plate

Scale Plates

OTC/1200,1201#B298 10/22/01, 9:49 AM9