User's Manual

UNPACKING AND INSTALLATION INSTRUCTIONS

6 PREPARATION OF THE OVEN

1. Open the bottom of the carton, bend the carton flaps

back and tilt the oven over to rest on plasticfoam

pad. Lift carton off oven and remove all packing

materials, WALL and TOP CABINET TEMPLATE,

Turntable and Turntable Support. DO NOT RE-

MOVE THE WAVEGUIDE COVER, which is located

on the right side wall of the oven cavity.

2. Check the oven for any damage, such as misaligned

or bent door, damaged door seals and sealing

surfaces, broken or loose door hinges and latches

and dents inside the cavity or on the door. If there is

any damage, do not operate the oven and contact

your dealer or SHARP AUTHORIZED SERVICER.

3. Turn oven on the side. See Figure 4.

4. Follow steps (A)-(D) to remove mounting plate from

the back of the oven as shown in Figure 4.

(A) Release mounting plate by pulling out the lever

that is on the bottom of the oven. See Figure 5.

(B) When lever is out, pull that side of the mounting

plate away from the oven. See Figure 4.

(D) Repeat step (B) on other side.

Figure 5

Use screwdriver to

assist in releasing

mounting plate.

Mounting Plate

Bottom of

Microwave

(A)

Figure 4

(C)

(D)

(B)

(A)

OTC/1200,1201#B298 10/22/01, 9:49 AM8